I decided to give making some ornaments a shot. These were made using my Mickey and Friends, Happily Ever After and Paper Doll Dress Up cartridges. They key to putting these together is a pair of fine tip or needle tip tweezers and lots of patience. I attempted to have one ornament laminated at Staples and my instinct that it probably wouldn't come out to great was right. The laminate they use is very heavy duty and thick and it does not get down into the layers enough which creates a bubbling effect. So my plan B was to try a self laminating sheets which are thinner and more pliable. I laid them down face first on sheet number one and kept the non stick backing on. Flipped them over and used a stylus for embossing to push the laminate down into the layers as best I could. Then I took sheet number two and put it on the back using a brayer. This was very tricky. Creasing was an issue on a couple of the ornaments but since it's not visible from the front it doesn't effect the overall appearance much. Thankfully this only happened on a couple. In the end I am pleased with how they came out but I don't think in the future I will be laminating them. I will probably experiment with another method of sealing them. Perhaps a paper friendly varnish or Mode Podge. If you're good with the laminate it's a decent method but it was a bit nerve wracking for me. So here they are my Disney Cricut ornaments.